The "-r 1" option tells the check_snmp plugin to return an OK state if "1" is found in the SNMP result (1 indicates an "up" state on the port) and CRITICAL if it isn't found. In the example above, the "-o ifOperStatus.1" refers to the OID for the operational status of port 1 on the switch. If you want to ensure that a specific port/interface on the switch is in an up state, you could add a service definition like this:Ĭheck_command check_snmp!-C public -o ifOperStatus.1 -r 1 -m RFC1213-MIB In the check_command directive of the service definition above, the "-C public" tells the plugin that the SNMP community name to be used is "public" and the "-o sysUpTime.0" indicates which OID should be checked. Use generic-service Inherit values from a templateĬheck_command check_snmp!-C public -o sysUpTime.0 If it doesn't, skip this section.Īdd the following service definition to monitor the uptime of the switch. If your switch or router supports SNMP, you can monitor a lot of information by using the check_snmp plugin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |